Bobcat S850 - Changing The Factory Default Setting

57 S850 Operation & Maintenance Manual
SPEED MANAGEMENT (CONT’D)
Changing The Factory Default Setting
The Speed Management factory default setting can be
cha
nged by the operator to save adjustment time.
EXAMPLE: Your machine is often used for
t
renching and you prefer a Speed Management
setting of 28% of Standard Travel Speed for that
application. The Speed Management default
setting can be changed to 28% of Standard Travel
Speed instead of the factory default setting of
57%. Each time you start the machine and first
select Speed Management, the machine will
default to 28% of Standard Travel Speed.
Engage Speed Management. (See Operation on Page
56.)
Figure 67
Adjust the speed percentage higher (Item 2) or lower
(I
tem 3) [Figure 67] by pressing the Speed Control
switch until the desired def
ault setting is displayed.
Press and hold the button (Item 1) [Figure 67] on the left
control to save the default setting.
Figure 68
The alarm will beep once, display [SET ##] [Figure 68]
(## will be the percentage y
ou selected) and remain in
Speed Management mode.
Pressing the button (Item 1) [Figure 67] on the left
control or turning the machine off will disengage Speed
Ma
nagement and return the loader to Standard Travel
Speed.
When Speed Management is first selected each time the
mac
hine is started, the percentage you selected will be
the default setting. Speed Management can still be
adjusted from 1% to 99% of Standard Travel Speed.
The default setting can be changed any time the operator
choo
ses.
P-24820C
2
3
1
P-24802C
Left Right
NA3270
59 of 210
Dealer Copy -- Not for Resale