Bobcat S850 - FRONT Auxiliary Hydraulics Operation (CONTINUOUS FLOW); FRONT Auxiliary Hydraulics Operation (REVERSE CONTINUOUS FLOW)

70 S850 Operation & Maintenance Manual
HYDRAULIC CONTROLS (CONT’D)
FRONT Auxiliary Hydraulics Operation
(CONTINUOUS FLOW)
Figure 84
After activating the auxiliary hydraulics, press the
con
tinuous flow control switch (Item 2) [Figure 84] to
allow constant auxiliary hydraulic oil flow
to the front
female coupler (female coupler is pressurized).
(EXAMPLE: Operate a backhoe.)
To stop continuous aux
iliary hydraulic oil flow, press the
continuous flow control switch (Item 2) [Figure 84] a
second time.
NOTE: When the operator is seated and raises the
s
eat bar, the Auxiliary Hydraulic System
(Front and Rear) will deactivate.
FRONT Auxiliary Hydraulics Operation (REVERSE
CONTINUOUS FLOW)
To allow constant auxiliary hydr
aulic oil flow to the front
male coupler (male coupler is pressurized):
1. Activate the auxiliary hydraulics.
2.
Move the front auxiliary hydraulic switch (Item 1)
[Figure 84] to the left and hold it there.
3. Press the continuous flow control switch (Item 2)
[Figure 84].
4. Release the front auxiliary hydraulic switch.
NOTE: Reverse flow can cause damage to some
attachments. Use reverse flow with your
attachment only if approved. See your
attachment Operation & Maintenance Manual
for detailed information.
To stop reverse continuous
auxiliary hydraulic oil flow,
press the continuous flow control switch (Item 2)
[Figure 84] a second time.
NOTE: When the operator is seated and raises the
seat bar, the Auxiliary Hydraulic System
(Front and Rear) will deactivate.
P-24820A
P-24802A
1
2
Left Right
72 of 210
Dealer Copy -- Not for Resale