86 S850 Operation & Maintenance Manual
STARTING THE ENGINE (CONT’D)
Cold Temperature Starting
EXPLOSION CAN CAUSE SERIOUS INJURY, DEATH
OR SEVERE ENGINE DAMAGE
DO NOT use ether or starting fluid with glow plug or
air intake heater systems.
W-2071-0415
If the temperature is below freezing, perform the following
to make starting the engine easier:
• Replace the engine oil with the correct type and
viscosity for the anticipated starting temperature.
(See Engine Oil Chart on Page 126.)
• Make sure the battery is fully charged.
• Install an engine heater, available from your Bobcat
loader dealer.
• Move engine speed control lever halfway before
starting. Return to idle position after the engine starts.
NOTE: The display screen of the Deluxe
Instrumentation Panel may not be at full
intensity when the temperature is below -26°C
(-15°F). It may take 30 seconds to several
minutes for the display screen to warm up. All
systems remain monitored even when the
display screen is off.
Warming The Hydraulic / Hydrostatic System
When the temperature is below -30°C (-20°F),
hydrostatic oil must be warmed before starting. The
hydrostatic system will not get enough oil at low
temperatures and will be damaged. Park the machine
in an area where the temperature will be above -18°C
(0°F) if possible.
I-2007-0910
Let the engine run for a minimum of five minutes to warm
the engine and hydrostatic transmission fluid before
operating the loader.
Dealer Copy -- Not for Resale
To Next Page
Loading...