144 S850 Operation & Maintenance Manual
HYDRAULIC / HYDROSTATIC SYSTEM (CONT’D)
Hydraulic / Hydrostatic Filter Identification
The filter housing is located behind the hydraulic fluid
reser
voir.
NOTE: Identification of the hydraulic / hydrostatic
f
ilter used on your machine is necessary to
perform the correct filter replacement
procedure.
Figure 234
Earlier models have a screw type filter cap [Figure 234].
Figure 235
Later models have a filter cap held in place by two bolts
[Figure 235].
Dealer Copy -- Not for Resale
To Next Page
Loading...