Bobcat S850 - Seat Adjustment

76 S850 Operation & Maintenance Manual
DAILY INSPECTION (CONT’D)
Daily Inspection And Maintenance (Cont’d)
The following list of items must be checked daily:
• Engine Oil Level
• Hydraulic Fluid Level
• Engine Air Filter - Check System for Damage or
Leaks
• Engine Cooling System - Check System for Damage
or Leaks, Check Coolant Level, Clean Oil Cooler,
Radiator and Rear Grille
• Operator Cab and Cab Mounting Hardware
•Seat Belt
• Seat Bar and Control Interlocks
• Bobcat Interlock Control System (BICS™)
• Front Horn and Back-up Alarm - Check for Proper
Function
• Grease Pivot Pins (Lift Arms, Lift Links, Bob-Tach,
Cylinders, Bob-Tach Wedges)
• Tires - Check for Wear, Damage, Correct Air
Pressure
• Fuel Filter - Remove Trapped Water
• Loose or Broken Parts - Repair or Replace as
Necessary
• Safety Treads and Safety Signs (Decals) - Replace as
necessary
• Lift Arm Support Device - Replace if Damaged
IMPORTANT
This machine is factory equipped with a U.S.D.A.
Forestry Service Approved spark arrester exhaust
system that must be maintained for proper function.
• WITH MUFFLER
The muffler spark chamber must be emptied
every 100 hours of operation to keep it in working
condition.
• WITH SELECTIVE CATALYST REDUCTION (SCR)
AND / OR DIESEL OXIDATION CATALYST (DOC)
Do not remove or modify the DOC or SCR.

The SCR must be maintained according to the
instructions in the Operation & Maintenance
Manual for proper function.
• WITH DIESEL PARTICULATE FILTER (DPF)
The DPF must be maintained according to the
instructions in the Operation & Maintenance
Manual for proper function.
(If this machine is operated on flammable forest,
brush or grass cover land, the engine must be
equipped with a spark arrester and maintained in
working order. Failure to do so will be in violation of
California state law section 4442 PRC. Refer to local
laws and regulations for spark arrester
requirements.)
I-2350-1114
IMPORTANT
PRESSURE WASHING DECALS
• Never direct the stream at a low angle toward the
decal that could damage the decal causing it to
peel from the surface.
• Direct the stream at a 90 degree angle and at
least 300 mm (12 in) from the decal. Wash from
the center of the decal toward the edges.
I-2226-0910
78 of 210
Dealer Copy -- Not for Resale