127
Z31900_00_01
Safety Notices
DANGER
Danger of injury from glass tube breakage!
Broken glass tubes may cause minor injuries or material damage, but may also result
in a life threatening situation if hazardous substances are used.
f If a glass tube breaks, refer to the corresponding precautions and cleaning/disin-
fection instructions.
f Wear protective equipment.
f Perform all tasks with the cassette and glass tubes carefully.
f Before carrying out any maintenance work, remove the samples and use dummy
samples if necessary.
f Strictly observe the correct sample adjustment, i.e. the maximum sample height.
f Always transport the cassette with the cover. Never turn the cassette upside down
or on a side.
The laboratory supervisor is responsible for:
f Establishing and enforcing standard sample handling and cleaning procedures.
f Establishing and enforcing the use of protective clothing and equipment.
f Training laboratory personnel.
f Preparing an emergency plan.
NOTICE
Material damage hazard from glass tube breakage or sample blockage
in the BST!
Material damage from glass breakage or samples becoming stuck in the BST may
result if non-OEM replacement parts are used.
f Replacement parts must meet OEM standards.
NOTICE
Material damage hazard from material contact with NMR solvents!
Material damage may result when the device comes in contact with NMR solvents.
f Follow instructions provided in the manual for correct handling of solvents.
f Follow the sensor cleaning procedures described in this manual.
f If surface damage should occur, contact Bruker for repair of damaged parts.
To Next Page
Loading...
