Canon imageCLASS D1120 - Editing Coded Dial Codes (Group Addresses)

Registering Destinations in the Address Book (D1180/D1170/D1150)
5-18
Storing/Editing Coded Dial Codes
For information on how to enter characters, see
“Entering Characters,” on p. 1-16.
8
Repeat steps 5 to 7 to edit the desired
items.
9
Press [Stop/Reset] to return to the
standby mode.
Editing Coded Dial Codes (Group
Addresses)
This section describes the procedure for adding a
new destination to the group, deleting a destination
from the group, or changing the group name
registered in the coded dial codes.
1
Press [Menu].
2
Press or to select <ADDRESS
BOOK SET.>, then press [OK].
5 . A D D R E S S B O O K S E T .
M E N U
If a password has been set for the Address Book,
enter the password using
–
[numeric keys],
then press [OK].
3
Press or to select <GROUP DIAL>,
then press [OK].
3 . G R O U P D I A L
A D D R E S S B O O K S E T .
4
Press [Coded Dial], enter the
three-digit code using – [numeric
keys].
[ * 1 0 0 ] G R O U P D I A L
G R O U P D I A L
■Ifyouwanttoaddanewdestinationto
thegroup:
①Press
or to select <SELECT ADD/TEL
NO>, then press [OK].
1 . S E L E C T A D D / T E L N O
G R O U P D I A L
②Select the destination you want to add to
the group, then press [OK].
[ * 0 0 2 ] s a l e s
= 2 3 4 X X X X X X X
Ex.
For details on specifying a destination from
Address Book, see “Registering Group Addresses in
Coded Dial Codes,” on p. 5-16.
■If you want to delete a destination from the
group:
①Press
or to select <SELECT ADD/TEL
NO>, then press [OK].
1 . S E L E C T A D D / T E L N O
G R O U P D I A L
②Press or to display the destination
you want to delete from the group, then
press
[Clear].
[ * 0 0 0 ] J o h n
= 1 2 3 X X X X X X X
Ex.
③Repeat step ② if you want to delete
another destination.
④
Press[OK].