Canon imageCLASS D1120 - Registering Group Addresses in Coded Dial Codes

Registering Destinations in the Address Book (D1180/D1170/D1150)
5-16
Storing/Editing Coded Dial Codes
14
Press or to select <PASSWORD>,
then press [OK].
5 . P A S S W O R D
C O D E D S P D D I A L
15
Use – , [numeric keys] and
[Tone] to enter the password (14
characters maximum), then press [OK].
1 2 3 X X X X
P A S S W O R D : a
Ex.
To register another coded dial code, repeat the
procedure from step 4.
16
Press [Stop/Reset] to return to the
standby mode.
Registering Group Addresses in
Coded Dial Codes
The Group Address feature enables you to create a
group of up to 199 stored destinations as a single
destination.
The destinations must be registered in coded dial codes
beforehand.
1
Press [Menu].
2
Press or to select <ADDRESS
BOOK SET.>, then press [OK].
5 . A D D R E S S B O O K S E T .
M E N U
If a password has been set for the Address Book,
enter the password using
–
[numeric keys],
then press [OK].
3
Press or to select <GROUP DIAL>,
then press [OK].
3 . G R O U P D I A L
A D D R E S S B O O K S E T .
4
Press [Coded Dial], enter the three-
digit code that you want to set as the
group address, and then press [OK].
[ * 1 0 0 ] N O T R E G I S T E R E D
G R O U P D I A L
5
Press or to select <SELECT ADD/
TEL NO>, then press [OK].
1 . S E L E C T A D D / T E L N O
G R O U P D I A L
6
Select the destinations you want to
register in the group (199 destinations
maximum) until all destinations are
registered, then press [OK].
[ * 0 0 0 ] J o h n
= 1 2 3 X X X X X X X
Ex.
To enter a destination stored under a coded dial
code, press
[Coded Dial], then enter the
three-digit code with
–
[numeric keys]. For
multiple entries, press
[Coded Dial] between
each entry.
You can review the destinations which have been
already entered with or .
7
Press or to select <NAME>, then
press [OK].
2 . N A M E
G R O U P D I A L