Canon imageCLASS D1120 - Registering File Server Addresses in Coded Dial Codes

Registering Destinations in the Address Book (D1180/D1170/D1150)
5-14
Storing/Editing Coded Dial Codes
2
Press or to select <ADDRESS
BOOK SET.>, then press [OK].
5 . A D D R E S S B O O K S E T .
M E N U
If a password has been set for the Address Book,
enter the password using
–
[numeric keys],
then press [OK].
3
Press or to select <CODED SPD
DIAL>, then press [OK].
2 . C O D E D S P D D I A L
A D D R E S S B O O K S E T .
4
Press or to select a coded dial
code (000 to 179) for which you want to
register the address, then press [OK].
[ * 0 0 0 ] N O T R E G I S T E R E D
C O D E D S P D D I A L
You can also select a coded dial code by
pressing
[Coded Dial] followed by the desired
three-digit code.
5
Press or to select <E-MAIL>, then
press [OK].
E - M A I L
C O D E D S P D D I A L
6
Press or to select <E-MAIL
ADDRESS>, then press [OK].
1 . E - M A I L A D D R E S S
C O D E D S P D D I A L
7
Use – , [numeric keys] and
[Tone] to enter the address you want
to register (120 digits maximum), then
press [OK].
J o h n @ e x a m p l . c o m
E - M A I L A D D R E S S : a
Ex.
For information on how to enter characters, see
“Entering Characters,” on p. 1-16.
8
Press or to select <NAME>, then
press [OK].
2 . N A M E
C O D E D S P D D I A L
9
Use – , [numeric keys] and
[Tone] to enter the destination’s name
(16 characters maximum), then press
[OK].
J o h n ( e - m a i l )
N A M E : a
Ex.
To register another coded dial code, repeat the
procedure from step 4.
10
Press [Stop/Reset] to return to the
standby mode.
Registering File Server Addresses
in Coded Dial Codes
This section describes the procedure for registering
file server addresses in the coded dial codes.
1
Press [Menu].
2
Press or to select <ADDRESS
BOOK SET.>, then press [OK].
5 . A D D R E S S B O O K S E T .
M E N U
If a password has been set for the Address Book,
enter the password using
–
[numeric keys],
then press [OK].