Canon imageCLASS D1120 - Erasing Coded Dial Codes

Registering Destinations in the Address Book (D1180/D1170/D1150)
5-19
Storing/Editing Coded Dial Codes
■If you want to change the group name:
①Press
or to select <NAME>, then
press [OK].
2 . N A M E
G R O U P D I A L
②Press repeatedly to go back to a wrong
character, then press
[Clear].
C a n o n G r o u p
N A M E : a
Ex.
To delete the entire name, press and hold
[Clear].
③Use – , [numeric keys] and [Tone]
to enter a new character, then press [OK].
S a l e s G r o u p
N A M E : a
Ex.
5
Press [Stop/Reset] to return to the
standby mode.
Erasing Coded Dial Codes
This section describes the procedure for erasing
addresses registered under coded dial codes.
1
Press [Menu].
2
Press or to select <ADDRESS
BOOK SET.>, then press [OK].
5 . A D D R E S S B O O K S E T .
M E N U
If a password has been set for the Address Book,
enter the password using
–
[numeric keys],
then press [OK].
3
Press or to select <CODED SPD
DIAL>, then press [OK].
2 . C O D E D S P D D I A L
A D D R E S S B O O K S E T .
4
Press or to select a coded dial
code (000 to 179) you want to erase, then
press [OK].
[ * 0 0 0 ] J o h n
C O D E D S P D D I A L
You can also select a coded dial code by
pressing
[Coded Dial] followed by the desired
three-digit code.
5
Press or to select <TEL NUMBER
ENTRY>, <E-MAIL ADDRESS>, or <HOST
NAME>, then press [OK].
1 . T E L N U M B E R E N T R Y
C O D E D S P D D I A L
6
Press and hold [Clear] to erase the
entire entry, then press [OK].
If you erase the fax number or e-mail address or
file server address, the registered name is cleared
automatically.
7
Press [Stop/Reset] to return to the
standby mode.