Canon imageCLASS D1120 - Page 222

Settings from a PC
10-5
Starting the Remote UI
4
Enter the required data.
The required data differs depending on the
authentication mode you are using.
■For default settings:
①Select [Administrator Mode] or [End-User
Mode].
②Enter the password or user name and click
[OK].
■In case no management mode is set, and
system manager ID and password are set:
①Select [Administrator Mode] or [End-User
Mode].
②For Administrator Mode, enter the system
manager password, and click OK. For End-
User Mode, enter the user ID and click [OK].