Cessna 182 1978 - Removal and Installation of Nose Wheel Steering System Components; Rigging of Nose Wheel Steering System; Brake System

MODEL 182 & T182 SERIES SERVICE MANUAL
2. Bearing End
Assembly 7. Rudder
Bar Arm
3. Steering Bungee
Assembly
8. Pivot Bolt
Figure 5-14. Nose Wheel Steering System (Model 182)
5-70. REMOVAL.
(Model
T182 thru 18268055.)
a. Install steering
bungee
assembly (9) such
that
(See figure 5-15.
)
shaft
is positioned
between ears of
rudder bar assem-
a.
Disconnect
bearing end assembly
(3) from
steer-
bly (7).
ing bellcrank
(2) on nose
gear strut.
b. Install
barrel nut
(11) and two
snap rings
(12).
b. Disconnect
rod end assembly
(6) from
rudder
c. Connect
bearing end assembly
(3) to steering
bar assembly
(7).
bellcrank (2)
on nose gear
strut.
c. Remove
sprocket
(8) from chain
assembly; re-
d. Install
flex shaft (13)
over shaft of
steering bun-
move steering bungee
assembly (9).
gee assembly (9);
install pin (14).
5-71. INSTALLATION. (Model T182 thru 18268055.) REMOVAL AND INSTALLATION OF NOSE
(See figure 5-15. ) WHEEL STEERING SYSTEM COMPONENTS. (See
Install chain assembly on sprocket (8). )figures 5-14 and 5-15. ) Use the applicable figure
a.
Install
chain
assembly
on
sprocket
(8).
as a guide in determining system component
b. Connect rod end assembly (6)on rudder bar as a guide in determining system component
b.
Connect
rod
end
assembly
(6)
to rudder
bar
relationship
and
for removal
and
installation
of
sys-
assembly
(7).
ter
components.
c. Connect bearing
end assembly
(3) to steering
bellcrank
(2)
on nose
gear
strut.
5-75.
RIGGING
OF
NOSE
WHEEL
STEERING
SYS-
TEM. Since the nose wheel steering system is
5-72. REMOVAL. (Model T182 beginning with directly connected to the rudder control system, ad-
18268056.
) (See figure
5-15. )
justment to one
system would
directly affect
the other.
a.
Disconnect
bearing end
assembly
(3) from steer-
Refer
to Section
10 of this
manual for
rigging pro-
ing
bellcrank (2) on
nose gear strut.
cedures
for the rudder
control system
and the nose
b. Remove
pin (14) and flex
shaft (13) from
shaft of wheel
steering system.
steering bungee assembly (9).
c. Remove
snap rings (12) and barrel nut (11),
5-76. BRAKE SYSTEM.
securing steering bungee
assembly (9)
to ears of
rudder bar assembly
(7).
5-77. DESCRIPTION.
The hydraulic brake
system
d.
Disconnect bearing
end assembly
(3) from steer-
is comprised
of two master
brake cylinders,
located
ing bungee
assembly
(9).
immediately
forward
of the
rudder
pedals,
brake
lines
5-73. INSTALLATION.
(Model T182 beginning
with cylinder,
and the single-disc,
floating cylinder-type
18268056.
) (See figure 5-15.)
brake assembly,
located at each main
landing gear
wheel.
5-29