Cessna 182 1978 - Elevators; Bellcrank

MODEL
182
& T182
SERIES
SERVICE
MANUAL
8-3.
TROUBLE
SHOOTING
(Cont).
TROUBLE
PROBABLE
CAUSE
REMEDY
BINDING
OR
JUMPY
MOTION
Defective
bellcrank
or
arm
Replace
defective
parts.
FELT
IN
MOVEMENT
OF ELE-
assembly
pivot
bearings
or
VATOR
SYSTEM.
push-pull
tube
attach
bearings.
Cables
slack.
Adjust
to tension
specified
in
figure
8-1.
Cables
not riding
correctly
on
Route
cables
correctly
over pulleys
pulleys.
Nylon
grommet
on
instrument
Replace
grommet.
panel
binding.
Defective
control
column
Replace
defective
rollers.
bearing
rollers.
Defective
control
column
Replace
defective
bearings.
torque
tube
bearings.
Control
guide
on aft
end of
Loosen
screw
and tapered
plug
control
square
tube
in
end
of control
tube
enough
to
adjusted
too tightly.
eliminate
binding.
Defective
elevator
hinges.
Replace
defective
hinges.
Defective
pulleys
or
cable
Replace
defective
parts
and
guards.
install
guards
properly.
ELEVATORS
FAIL
TO ATTAIN
Stops
incorrectly
set.
Rig
in accordance
with
para-
PRESCRIBED
TRAVEL.
graph
8-14.
Cables
tightened
unevenly.
Rig in
accordance
with
para-
graph 8-14.
Interference
at instrument
Rig
in accordance
with
para-
panel.
graph
8-14.
8-4.
CONTROL
COLUMN.
(See
figure
6-2.)
e.
Using
care,
remove
elevator.
Section
6
outlines
removal,
installation
and
repair
of
f.
To
remove
left
elevator
use
same
procedure,
control
column.
omitting
step
"b".
8-5.
ELEVATORS.
(See
figure
8-2.)
8-7.
REPAIR.
Repair
may
be accomplished
as
out-
8-6.
REMOVAL
AND
INSTALLATION.
lined
in Section
18.
Hinge
bearings
may
be
replaced
a.
Remove
stinger.
as
necessary.
If repair
has
affected
static
balance,
b.
Disconnect
trim
tab
push-pull
tube
(6)
at tab
actu-
check
and
rebalance
as required.
ator.
8-8.
BELLCRANK.
(See
figure
8-3.)
NOTE
8-9.
REMOVAL
AND
INSTALLATION.
If trim
system
is
not
moved
and
actuator
a.
Remove
access
plate
below
bellcrank
on
tailcone.
screw
is
not
turned,
re-rigging
of
trim
system
should
not
be
necessary
after
re-
installation
of
elevator.
Position
a
support
stand
under
tail
tie-down
c.
Remove
bolts
(13)
securing
elevator
torque
tubes
ring
to
prevent
the
tailcone
from
dropping
(3) to
arm
assembly
(4).
while
working
inside.
d.
Remove
bolts
(14)
from
elevator
hinges.
8-2