Cessna 182 1978 - Ground Handling, Servicing, Cleaning, Lubrication and Inspection

MODEL
182 &
T182 SERIES
SERVICE
MANUAL
SECTION
2
GROUND
HANDLING,
SERVICING, CLEANING,
LUBRICATION
AND INSPECTION
WARNING
When
performing
any inspection
or
maintenance
that
requires turning on
the master switch, install-
ing a battery,
or pulling the propeller
through by
hand, treat
the propeller as if the
ignition switch
were ON. Do not stand, nor allow anyone else to
stand within
the arc of the propeller,
since a loose or
broken wire.
or a component
malfunction could
cause the propeller to rotate.
Page
No.
Page No.
TABLE
OF CONTENTS
Aerofiche/Manual
TABLE
OF CONTENTS
Aerofiche/Manual
GROUND HANDLING ......... . 1B12/2-2 Carburetor Drain Plug
Towing ...................... 1B12/2-2 Inspection .................. B20/2-10
Hoisting ....................... 1B14/2-4 Engine Oil ...................... 1B20/2-10
Jacking ....................... B14/2-4 Engine Induction Air Filter ...... 1B21/2-11
Leveling..... .... 1B14/2-4 Vacuum System Filter .......... 1B21/2-11
Weighing ....................... 1B14/2-4 Battery . ....................... 1B22/2-12
Parking ....................... 1B14/2-4 Tires ........................... 1B22/2-12
Tie-Down .................... 1B14/2-4 Nose Gear Shock Strut ........... 1B22/2-12
Flyable Storage Nose Gear Shimmy Dampener .... B22/2-12
(Lycoming Engines) .........
B14/2-4 Hydraulic Brake
System ........ 1B22/2-12
Flyable Storage CLEANING ....................... 1B22/2-12
(Continental Engines) ....... B14/2-4 General Description ............. 1B22/2-12
Returning Aircraft
to Service .... 1B15/2-5
Windshields and Windows ....... 1B23/2-13
Temporary Storage
.............. 1B15/2-5
Materials Required ......... 1B23/2-13
Inspection During Storage ....... 1B16/2-6 Waxing . ................... B23/2-13
Returning Aircraft
to Service ..... 1B16/2-6
Preventive Maintenance ..... 1B23/2-13
Indefinite Storage Interior Trim ................ 1B24/2-14
(Lycoming Engines) ......... B16/2-6 Painted Surfaces ............... 1B24/2-14
Indefinite Storage Aluminum Surfaces ............. 1B24/2-14
(Continental Engines) .....
1B17/2-7 Engine/Engine Compartment
.... 1B24/2-14
Inspection During Storage Upholstery and Interior .......... 1C1/2-15
(Lycoming Engines)
......... 1B18/2-8
Propeller ....................... 1C1/2-15
Inspection During
Storage
Wheels ......................... 1C1/2-15
(Continental Engines) ...... 1B18/2-8
LUBRICATION ....................
1C1/2-15
Returning Aircraft toService
..... 1B18/2-8 General
Description ............ 1C112-15
SERVICING ....................... 1B19/2-9 TachometerDrive Shaft ......... C1/2-15
General Description ..........
1B192-9 Wheel Bearings
................. 1C1/2-15
Fuel .... ................... 1B19/2-9
NoseGearTorqueLinks
......... 1C12-15
Use of Fuel Additives For WingFlap Actuator ............ 1C1/2-15
Cold Weather Operation ....
1B19/2-9 Rod End Bearings
............... 1C1/2-15
Fuel Drains ...................
1B19/2-9 GENERAL
INSPECTION ........... 1C10/2-24
Revision 3 2-1