Cessna 182 1978 - Page 403

MODEL 182 & T182 SERIES SERVICE MANUAL
7. Fill tanks to capacity, apply electrical power as required and verify that the fuel quantity indicators
indicate "FULL".
A. If "FULL" is not indicated, adjust, troubleshoot, repair and/or replace fuel indicating
components as required until the "FULL" indication is achieved.
NOTE: Stewart Warner fuel quantity indicating systems can be adjusted. Refer to instructions for
adjusting Stewart Warner fuel indicating systems in this section.
Rochester fuel quantity indicating system components are not adjustable, only component
replacement or standard electrical wiring system maintenance practices are permitted.
8. Install any items and/or equipment removed to accomplish this procedure, remove maintenance
warning tags and connect the airplane battery.
Temporary
Revision
Number
3
© 2002 Cessna Aircraft Company 7 October 2002 15-24D