Chroma A620028 - Page 204

Programmable DC Power Supply (with Solar Array Simulation) 62000H Series
Operating & Programming Manual
5-34
Query Example: SOUR:VOLT:SLEW? Returns the output voltage slew rate
setting.
Return Example: 1.000000e+01
5. SOURce: CURRent
Description: Sets the output current (ampere).
Syntax: SOURce:CURRent <NRf+>[suffix]
SOURce:CURRent <NRf+>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOUR:CURR 1 Sets the output current to 1 amp.
SOUR:CURR 60.00 Sets the output current to 60.00 amps.
Query Syntax: SOUR:CURR?
Return Parameter: <NRf+> [Unit Amp]
Query Example: SOUR:CURR? Returns the output current setting.
Return Example: 1.000000e+00
6. SOURce:CURRent:LIMit:{HIGH/LOW}
Description: Sets the output current range.
Syntax: SOURce:CURRent:LIMIT:HIGH <NRf+>[suffix]
SOURce:CURRent:LIMIT:LOW <NRf+>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOUR:CURR:LIMIT:HIGH 60.0 Sets the output current range
to 60A maximum.
SOUR:CURR:LIMIT:LOW 20.0 Sets the low limit to 20A for
current output protection.
Query Syntax: SOUR:CURR:LIMIT:HIGH?
SOUR:CURR:LIMIT:LOW?
Return Parameter: <NRf+> [Unit Amp]
Query Example: SOUR:CURR:LIMIT:HIGH? Returns the maximum range set
for current.
Return Example: 6.000000e+01
7. SOURce:CURRent:PROTect:HIGH
Description: Sets the current range for over current protection.
Syntax: SOURce:CURRent:PROTect:HIGH <NRf+>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOUR:CURR:PROT:HIGH 60.0 Sets the high limit to 60A
for current output protection.
Query Syntax: SOUR:CURR:PROT:HIGH?
Return Parameter: <NRf+> [Unit Amp]
Query Example: SOUR:CURR:PROT:HIGH? Returns the high limit setting for
current protection.
Return Example: 6.000000e+01
8. SOURce:CURRent:SLEW
Description: Sets the rising or falling slew rate (amp/ms) of output current.
Syntax: SOURce:CURRent:SLEW <NR1>[suffix]
SOURce:CURRent:SLEW <NR1>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOUR:CURR:SLEW 0.01 Sets the output current slew rate to
0.01 Amp/mS.
SOUR:CURR:SLEW 1.00 Sets the output current slew rate to
1.00 Amp/mS.
Query Syntax: SOUR:CURR:SLEW?