Chroma A620028 - Page 205

Remote Operation
5-35
Return Parameter: <NR1> [Unit Amp/ms]
Query Example: SOUR:CURR:SLEW? Returns the current slew rate setting.
Return Example: 1.000000e+00
9. SOURce:CURRent:SLEWINF
Description: Sets the I Slewrate to INF.
Syntax: SOURce:CURRent:SLEWINF ENABLE
SOURce:CURRent:SLEWINF DISABLE
Parameter: ENABLE/DISABLE
Example: SOUR:CURR:SLEWINF ENABLE Sets the I Slewrate to INF.
SOUR:CURR:SLEWINF DISABLE It resets the I Slewrate and
returns to 1A/ms.
Query Syntax: SOUR:CURR:SLEW?
Return Parameter: INF. Or <NRf+>[Unit = Ampere]
Query Example: SOUR:CURR:SLEW? Returns the Slewrate
setting.
Return Example: INF.
10. SOURce:POWer:PROTect:HIGH
Description: Sets the over power point (Watt) of output power.
Syntax: SOURce:POWer:PROTect:HIGH <NR1>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOURce:POWer:PROTect:HIGH 1260 Sets the over power
point to 1260W.
Query Syntax: SOURce:POWer:PROTect:HIGH?
Return Parameter: <NR1> [Watt]
Query Example: SOURce:POWer:PROTect:HIGH? Returns the over
power setting.
Return Example: 1.260000e+03
11. SOURce:DCON:{RISE/FALL}
Description: Sets the DC_ON signal active point.
Syntax: SOURce:DCON:RISE <NRf+>[suffix]
SOURce:DCON:FALL <NRf+>[suffix]
Parameter: Refer to individual spec for valid numeric range.
Example: SOUR:DCON:RISE 79.5 Sets the DC_ON rise to 79.5V.
SOUR:DCON:FALL 0.5 Sets the DC_ON fall to 0.5V.
Query Syntax: SOUR:DCON:RISE?
SOUR:DCON:FALL?
Return Parameter: <NRf+> [Unit = Volt]
Query Example: SOUR:DCON:RISE? Returns the DC_ON setting.
Return Example: 7.950000e+01
Note
The output must be OFF for setting.