Chroma A620028 - Page 213

Remote Operation
5-43
7. IVCurve:IT
Description: Creates the 128 dot current data table in IV Curve Mode.
Syntax: IVCurve:IT <NRf+>...< NRf+>
Example: Creates the current table of IV Curve data.
IVCurve:IT <I1>,<I2>,...<I128>
Query Syntax: IVCurve:IT?
Return Parameter: <NRf+>,...,<NRf+>
Query Example: IVCurve:IT?
Return Example: <I1>,<I1>,...<I128>
Note
The execution time of this command is longer in Master/Slave mode. To ensure
normal operation, use the *OPC command. It will run the next command after the
*OPC command responds.
Ex.: IVC:VT xxx,xxx,xxx,...
*OPC?
8. IVCurve:EDIT <NR1>
Description: Selects the stored table to be edited in IV Curve Mode. There are
100 stored tables (1-100). The default is 1.
Syntax: IVCurve:EDIT <NR1>
Example: Selects the IV Curve stored in table 1 for editing.
IVCurve:EDIT 1
Query Syntax: IVCurve:EDIT?
Return Parameter: <NR1>
Query Example: IVCurve:EDIT?
Return Example: 1
9. IVCurve:SELect <NR1>
Description: Selects the stored table to be run in IV Curve Mode. There are 100
stored tables (1-100). The default is 1.
Syntax: IVCurve:SELect <NR1>
Example: Selects the IV Curve stored in table 1 for execution.
IVCurve:SELect 1
Query Syntax: IVCurve:SELect?
Return Parameter: <NR1>
Query Example: IVCurve:SELect?
Return Example: 1
10. IVCurve:SEQuence:SELected
Description: Selects the sequence of the programs for the IV_PROGRAM.
Syntax: IVCurve:SEQuence:SELected <NR1>
Parameter: 1 to 100
Example: IVC:SEQ:SEL 3
Query Syntax: IVC:SEQuence:SELected?
Return Parameter: <NR1>
Query Example: IVC:SEQ:SEL?
Return Example: 3
Note
Ensure the IV-Program has the desired sequence before selecting it. If not, use
the PROG:ADD command to add a new Sequence.