Cisco Catalyst 3750-X User Manual

49-10
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 49 Configuring MSDP
Configuring MSDP
To remove the filter, use the no ip msdp redistribute global configuration command.
Step 3
access-list access-list-number {deny |
permit} source [source-wildcard]
or
access-list acces
s-list-number {deny |
permit} protocol source source-wildcard
destination destination-wildcard
Create an IP standard access list, repeating the command as many times
as nece
ssary.
or
Create an IP extended access list, r
epeating the command as many times
as necessary.
• For access-list-number, the range is 1 to 99 for standard access lists
and 100 to 199 for extended lists. Enter the same number created in
St
ep 2.
• The deny keyword denies access if the conditions are matched. The
permit keyword permits access if the conditions are matched.
• For protocol, enter ip as the protocol name.
• For source, enter the number of the network or host from which the
packet is being sent.
• For source-wildcard, enter the wildcard bits in dotted decimal
notation to be applied to the source. Place ones in the bit positions
that you want to ignore.
• For destination, enter the number of the network or host to which
the packet is being sent.
• For destination-wildcard, enter the wildcard bits in dotted decimal
notation to be applied to the destination. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always t
erminated by an implicit deny
statement for everything.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing