Cisco Catalyst 3750-X User Manual

C-7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Appendix C Unsupported Commands in Cisco IOS Release 12.2(53)SE2
IP Multicast Routing
IP Multicast Routing
Unsupported Privileged EXEC Commands
clear ip rtp header-compression [type number]
The deb
ug ip packet command displays packets received by the switch CPU. It does not display packets
that are hardware-switched.
The deb
ug ip mcache command affects packets received by the switch CPU. It does not display packets
that are hardware-switched.
The deb
ug ip mpacket [detail] [access-list-number [group-name-or-address] command affects only
packets received by the switch CPU. Because most multicast packets are hardware-switched, use this
command only when you know that the route will forward the packet to the CPU.
debug ip pim atm
show frame-relay ip rtp header-compression [interface type nu
mber]
The sho
w ip mcache command displays entries in the cache for those packets that are sent to the switch
CPU. Because most multicast packets are switched in hardware without CPU involvement, you can use
this command, but multicast packet information is not displayed.
The sho
w ip mpacket commands are supported but are only useful for packets received at the switch
CPU. If the route is hardware-switched, the command has no effect because the CPU does not receive
the packet and cannot display it.
show ip pim vc [gr
oup-address | name] [type number]
show ip rtp header-compression [t
ype number] [detail]
Unsupported Global Configuration Commands
ip multicast-routing vrf vrf-name
ip pim accept-rp {ad
dress | auto-rp} [group-access-list-number]
ip pim message-interval second
s
Unsupported Interface Configuration Commands
frame-relay ip rtp header-compression [active | passive]
frame-relay map ip ip-
address dlci [broadcast] compress
frame-relay map ip ip-
address dlci rtp header-compression [active | passive]
ip igmp helper-address ip
-address
ip multicast helper-map {gr
oup-address | broadcast} {broadcast-address | multicast-address}
extended-access-list-number
ip multicast rate-limit {in | out} [vi
deo | whiteboard] [group-list access-list] [source-list access-list]
kbps
ip multicast ttl-threshold tt
l-value (instead, use the ip multicast boundary access-list-number
interface configuration command)

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing