EasyManuals Logo

Cisco Catalyst 3750-X User Manual

Cisco Catalyst 3750-X
1438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #876 background imageLoading...
Page #876 background image
38-4
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 38 Configuring IPv6 ACLs
Configuring IPv6 ACLs
Configuring IPv6 ACLs
Before configuring IPv6 ACLs, you must select one of the dual IPv4 and IPv6 SDM templates.
To filter IPv6 traffic, you perform these steps:
Step 1 Create an IPv6 ACL, and enter IPv6 access list configuration mode.
Step 2 Configure the IPv6 ACL to block (deny) or pass (permit) traffic.
Step 3 Apply the IPv6 ACL to an interface. For router ACLs, you must also configure an IPv6 address on the
Layer 3 interface to which the ACL is applied.
These sections describe how to configure and apply IPv6 ACLs:
Default IPv6 ACL Configuration, page 38-4
Interaction with Other Features and Switches, page 38-4
Creating IPv6 ACLs, page 38-5
Applying an IPv6 ACL to an Interface, page 38-7
Default IPv6 ACL Configuration
There are no IPv6 ACLs configured or applied.
Interaction with Other Features and Switches
If an IPv6 router ACL is configured to deny a packet, the packet is not routed. A copy of the packet
is sent to the Internet Control Message Protocol (ICMP) queue to generate an ICMP unreachable
message for the frame.
If a bridged frame is to be dropped due to a port ACL, the frame is not bridged.
You can create both IPv4 and IPv6 ACLs on a switch or switch stack, and you can apply both IPv4
and IPv6 ACLs to the same interface. Each ACL must have a unique name; an error message appears
if you try to use a name that is already configured.
You use different commands to create IPv4 and IPv6 A
CLs and to attach IPv4 or IPv6 ACLs to the
same Layer 2 or Layer 3 interface. If you use the wrong command to attach an ACL (for example,
an IPv4 command to attach an IPv6 ACL), you receive an error message.
You cannot use MAC ACLs to filter IPv6 frames. MAC ACLs can only filter non-IP frames.
If the hardware memory is full, for any additional configured ACLs, packets are forwarded to the
CPU, and the ACLs are applied in software.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals