Cisco Catalyst 3750-X User Manual

11-35
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 11 Configuring IEEE 802.1x Port-Based Authentication
Configuring 802.1x Authentication
• Configuring a Web Authentication Local Banner, page 11-65 (optional)
• Disabling 802.1x Authentication on the Port, page 11-66 (optional)
• Resetting the 802.1x Authentication Configuration to the Default Values, page 11-66 (optional)
• Configuring MKA and MACsec, page 11-67 (optional)
Default 802.1x Authentication Configuration
Ta ble 11-4 Default 802.1x Authentication Configuration
Feature Default Setting
Switch 802.1x enable state Disabled.
Per-port 802.1x enable state Disabled (force-authorized).
The port sends and receives normal traf
fic without 802.1x-based
authentication of the client.
AAA Disabled.
RADIUS server
• IP address
• UDP authentication port
• Key
• None specified.
• 1812.
• None specified.
Host mode Single-host mode.
Control direction Bidirectional control.
Periodic re-authentication Disabled.
Number of seconds between re-authentication
attempt
s
3600 seconds.
Re-authentication number 2 times (number of times that the switch restarts the authentication process
b
efore the port changes to the unauthorized state).
Quiet period 60 seconds (number of seconds that the switch remains in the quiet state
fo
llowing a failed authentication exchange with the client).
Retransmission time 30 seconds (number of seconds that the switch should wait for a response to
an EA
P request/identity frame from the client before resending the request).
Maximum retransmission number 2 times (number of times that the switch will send an EAP-request/identity
fr
ame before restarting the authentication process).
Client timeout period 30 seconds (when relaying a request from the authentication server to the
cli
ent, the amount of time the switch waits for a response before resending the
request to the client.)
Authentication server timeout period 30 seconds (when relaying a response from the client to the authentication
serv
er, the amount of time the switch waits for a reply before resending the
response to the server.)
You can change this timeout period by using the dot
1x timeout
server-timeout interface configuration command.
Guest VLAN None specified.
Inaccessible authentication bypass Disabled.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing