EasyManuals Logo

Cisco Catalyst 3750-X User Manual

Cisco Catalyst 3750-X
1438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #875 background imageLoading...
Page #875 background image
38-3
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 38 Configuring IPv6 ACLs
Understanding IPv6 ACLs
Routed or bridged packets with hop-by-hop options have IPv6 ACLs applied in software.
Logging is supported for router ACLs, but not for port ACLs.
The switch supports IPv6 address-matching for a full range of prefix-lengths.
IPv6 ACL Limitations
With IPv4, you can configure standard and extended numbered IP ACLs, named IP ACLs, and MAC
ACLs. IPv6 supports only named ACLs.
The switch supports most Ci
sco IOS-supported IPv6 ACLs with some exceptions:
The switch does not support matching on these keywords: flowlabel, routing header, and
undetermined-transport.
The switch does not support reflexive ACLs (the reflect keyword).
This release supports only port ACLs and router ACLs for IPv6; it does not support VLAN ACLs
(VLAN maps).
The switch does not apply MAC-based ACLs on IPv6 frames.
You cannot apply IPv6 port ACLs to Layer 2 EtherChannels.
The switch does not support output port ACLs.
Output router ACLs and input port ACLs for IPv6 are supported only on switch stacks. Switches
support only control plane (incoming) IPv6 ACLs.
When configuring an ACL, there is no restriction on keywords entered in the ACL, regardless of
whether or not they are supported on the platform. When you apply the ACL to an interface that
requires hardware forwarding (physical ports or SVIs), the switch checks to determine whether or
not the ACL can be supported on the interface. If not, attaching the ACL is rejected.
If an ACL is applied to an interface and you attempt to add an access control entry (ACE) with an
unsupported keyword, the switch does not allow the ACE to be added to the ACL that is currently
attached to the interface.
IPv6 ACLs and Switch Stacks
The stack master supports IPv6 ACLs in hardware and distributes the IPv6 ACLs to the stack members.
Note For full IPv6 functionality in a switch stack, all stack members must be running the IP services feature
set.
If a new switch takes over as stack master, it distributes the ACL configuration to all stack members. The
member switches sync up the configuration distributed by the new stack master and flush out entries that
are not required.
When an ACL is modified, atta
ched to, or detached from an interface, the stack master distributes the
change to all stack members.

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals