Cisco Catalyst 3750-X - Page 1429

Index
IN-53
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
subnet mask 42-7
subnet zero 42-7
success response, VMPS 15-26
summer time 7-13
SunNet Manager 1-6
supernet 42-8
supported port-based authentication methods 11-8
Smartports macros
See also Auto Smartports macros
SVI autostate exclude
configuring
13-39
defined 13-6
SVI link state 13-6
SVIs
and IP unicast routing
42-5
and router ACLs 37-4
connecting VLANs 13-12
defined 13-5
routing between VLANs 15-2
switch 43-2
switch clustering technology 6-1
See also clusters, switch
switch console port
1-7
Switch Database Management
See SDM
switched packets, ACLs on
37-39
Switched Port Analyzer
See SPAN
switched ports
13-2
switchport backup interface 23-4, 23-5
switchport block multicast command 28-8
switchport block unicast command 28-8
switchport command 13-27
switchport mode dot1q-tunnel command 19-7
switchport protected command 28-7
switch priority
MSTP
21-22
STP 20-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP
42-48
syslog
See system message logging
system capabilities TLV
30-2
system clock
configuring
daylight saving time
7-13
manually 7-11
summer time 7-13
time zones 7-12
displaying the time and date 7-12
overview 7-2
See also NTP
system description TLV
30-2
system message logging
default configuration
34-4
defining error message severity levels 34-9
disabling 34-4
displaying the configuration 34-14
enabling 34-5
facility keywords, described 34-14
level keywords, described 34-10
limiting messages 34-10
message format 34-2
overview 34-1
sequence numbers, enabling and disabling 34-8
setting the display destination device 34-5
stack changes, effects of 34-2
synchronizing log messages 34-6
syslog facility 1-16
time stamps, enabling and disabling 34-8
UNIX syslog servers
configuring the daemon
34-12
configuring the logging facility 34-13
facilities supported 34-14
system MTU
and IS-IS LSPs
42-69