Cisco Catalyst 3750-X User Manual

10-21
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 10 Configuring Switch-Based Authentication
Controlling Switch Access with RADIUS
Table 10-3 shows the possible values for the Error-Cause attribute.
Preconditions
To use the CoA interface, a session must already exist on the switch. CoA can be used to identify a
session and enforce a disconnect request. The update affects only the specified session.
CoA Request Response Code
The CoA Request response code can be used to convey a command to the switch. The supported
commands are listed in Table 10-4 on page 10-23.
Ta ble 10-2 Supported IETF Attributes
Attribute Number Attribute Name
24 State
31 Calling-Station-ID
44 Acct-Session-ID
80 Message-Authenticator
101 Error-Cause
Ta ble 10-3 Error-Cause Values
Value Explanation
201 Residual Session Context Removed
202 Invalid EAP Packet (Ignored)
401 Unsupported Attribute
402 Missing Attribute
403 NAS Identification Mismatch
404 Invalid Request
405 Unsupported Service
406 Unsupported Extension
407 Invalid Attribute Value
501 Administratively Prohibited
502 Request Not Routable (Proxy)
503 Session Context Not Found
504 Session Context Not Removable
505 Other Proxy Processing Error
506 Resources Unavailable
507 Request Initiated
508 Multiple Session Selection Unsupported

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing