Cisco Catalyst 3750-X User Manual

11-28
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 11 Configuring IEEE 802.1x Port-Based Authentication
Understanding IEEE 802.1x Port-Based Authentication
Note If you use a dynamic VLAN to assign a voice VLAN on an MDA-enabled switch port, the voice
device fails authorization.
• To authorize a voice device, the AAA server must be configured to send a Cisco Attribute-Value
(AV) pair attribute with a value of
device-traffic-class=voice. Without this value, the switch
treats the voice device as a data device.
• The guest VLAN and restricted VLAN features only apply to the data devices on an MDA-enabled
port. The switch treats a voice device that fails authorization as a data device.
• If more than one device attempts authorization on either the voice or the data domain of a port, it is
error disabled.
• Until a device is authorized, the port drops its traffic. Non-Cisco IP phones or voice devices are
allowed into both the data and voice VLANs. The data VLAN allows the voice device to contact a
DHCP server to obtain an IP address and acquire the voice VLAN information. After the voice
device starts sending on the voice VLAN, its access to the data VLAN is blocked.
• A voice device MAC address that is binding on the data VLAN is not counted towards the port
security MAC address limit.
• You can use dynamic VLAN assignment from a RADIUS server only for data devices.
• MDA can use MAC authentication bypass as a fallback mechanism to allow the switch port to
connect to devices that do not support IEEE 802.1x authentication. For more information, see the
“MAC Authentication Bypass” section on page 11-38.
• When a data or a voice device is detected on a port, its MAC address is blocked until authorization
succeeds. If the authorization fails, the MAC address remains blocked for 5 minutes.
• If more than five devices are detected on the data VLAN or more than one voice device is detected
on the voice VLAN while a port is unauthorized, the port is error disabled.
• When a port host mode is changed from single- or multihost to multidomain mode, an authorized
data device remains authorized on the port. However, a Cisco IP phone that has been allowed on the
port voice VLAN is automatically removed and must be reauthenticated on that port.
• Active fallback mechanisms such as guest VLAN and restricted VLAN remain configured after a
port changes from single- or multihost mode to multidomain mode.
• Switching a port host mode from multidomain to single- or multihost mode removes all authorized
devices from the port.
• If a data domain is authorized first and placed in the guest VLAN, non-IEEE 802.1x-capable voice
devices need to tag their packets on the voice VLAN to trigger authentication.
• We do not recommend per-user ACLs with an MDA-enabled port. An authorized device with a
per-user ACL policy might impact traffic on both the voice and data VLANs of the port. If used,
only one device on the port should enforce per-user ACLs.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing