EasyManuals Logo

Cisco Catalyst 3750-X User Manual

Cisco Catalyst 3750-X
1438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #720 background imageLoading...
Page #720 background image
28-12
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 28 Configuring Port-Based Traffic Control
Configuring Port Security
VLAN, but is not learned on the access VLAN. If you connect a single PC to the Cisco IP phone,
no additional MAC addresses are required. If you connect more than one PC to the Cisco IP phone,
you must configure enough secure addresses to allow one for each PC and one for the phone.
When a trunk port configured with port security and assigned to an access VLAN for data traffic
and to a voice VLAN for voice traffic, entering the switchport voice and switchport priority
extend interface configuration commands has no effect.
When a connected device uses the same MAC address to reque
st an IP address for the access VLAN
and then an IP address for the voice VLAN, only the access VLAN is assigned an IP address.
When you enter a maximum secure address value for an interface, and the new value is greater than
the previous value, the new value overwrites the previously configured value. If the new value is less
than the previous value and the number of configured secure addresses on the interface exceeds the
new value, the command is rejected.
The switch does not support port security aging of sticky secure MAC addresses.
Table 28-3 summari
zes port security compatibility with other port-based features.
Ta ble 28-3 Port Security Compatibility with Other Switch Features
Type of Port or Feature on Port Compatible with Port Security
DTP
1
port
2
1. DTP = Dynamic Trunking Protocol
2. A port configured with the switchport mode dynamic interface configuration command.
No
Trunk port Yes
Dynamic-access port
3
3. A VLAN Query Protocol (VQP) port configured with the switchport access vlan dynamic interface configuration command.
No
Routed port No
SPAN source port Ye s
SPAN destination port No
EtherChannel No
Tunneling port Yes
Protected port Yes
IEEE 802.1x port Yes
Voice VLAN port
4
4. You must set the maximum allowed secure addresses on the port to two plus the maximum number of secure addresses
allowed on the access VLAN.
Yes
Private VLAN port No
IP source guard Ye s
Dynamic Address Resolution Protocol (ARP) inspection Yes
Flex Links Yes

Table of Contents

Other manuals for Cisco Catalyst 3750-X

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3750-X and is the answer not in the manual?

Cisco Catalyst 3750-X Specifications

General IconGeneral
Switching Capacity160 Gbps
Stacking Bandwidth64 Gbps
Max Stacking Units9
Layer SupportLayer 2 and Layer 3
Form FactorRack-mountable
DRAM256 MB
Flash Memory64 MB
ModelCisco Catalyst 3750-X Series
Ports24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces4 SFP or 2 SFP+
FeaturesStackWise Plus, EnergyWise
ImageIP Base or IP Services
Operating Temperature0 to 40°C
Operating Humidity10 to 85% noncondensing

Related product manuals