Cisco Catalyst 3750-X User Manual

37-42
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-21521-01
Chapter 37 Configuring Network Security with ACLs
Displaying IPv4 ACL Configuration
You can also display information about VLAN access maps or VLAN filters. Use the privileged EXEC
commands in Table 37-3 to display VLAN map information.
show ip interface interface-id Display detailed configuration and status of an interface. If IP is enabled
on the interface and ACLs have been applied by using the ip access-group
interface configuration command, the access groups are included in the
display.
show running-config [interface int
erface-id] Displays the contents of the configuration file for the switch or the
specified interface, including all configured MAC and IP access lists and
which access groups are applied to an interface.
show mac access-group [interface interface-id]
Displays MAC access lists applied to all Layer 2 interf
aces or the specified
Layer 2 interface.
Table 37-2 Commands for Displaying Access Lists and Access Groups (continued)
Command Purpose
Ta ble 37-3 Commands for Displaying VLAN Map Information
Command Purpose
show vlan access-map [m
apname] Show information about all VLAN access maps or the
specified access map.
show vlan filter [access-map na
me | vlan vlan-id] Show information about all VLAN filters or about a specified
VLAN or VLAN access map.

Cisco Catalyst 3750-X Specifications

General

Switching Capacity	160 Gbps
Stacking Bandwidth	64 Gbps
Max Stacking Units	9
Layer Support	Layer 2 and Layer 3
Form Factor	Rack-mountable
DRAM	256 MB
Flash Memory	64 MB
Model	Cisco Catalyst 3750-X Series
Ports	24 or 48 10/100/1000 Ethernet ports
Uplink Interfaces	4 SFP or 2 SFP+
Features	StackWise Plus, EnergyWise
Image	IP Base or IP Services
Operating Temperature	0 to 40°C
Operating Humidity	10 to 85% noncondensing