Cisco SPA IP Phone Field Reference
Attendant Console Tab (Cisco SPA500 and Cisco SPA500DS)
Cisco Small Business SPA300 Series, SPA500 Series, and WIP310 IP Phone Administration Guide 359
A
Test Mode Enable Enables or disables test mode. When test mode is
enabled, the LEDs are turned on when keys are
pressed, going from off to green to red, and back
to off. In test mode, when all the buttons on the
Cisco Attendant Console are returned to off, all
the keys become orange. The IP phone must be
rebooted after the test is completed.
Attendant Console Call
Pickup Code
The star code used for picking up a ringing call.
Defaults to *98.
Attendant Console Call
Park Code
Attendant Console Call
unPark Code
Not supported on Cisco SPA501, SPA502, and
SPA301 phones.
You can configure a dedicated call park button to
park a call, unpark a call and monitor the parking
lot status. For more information on configuring call
park buttons, see the “Unused line keys can be
enabled to allow call park (for the MetaSwitch
soft switch) on the Cisco SPA300 and SPA500
series phones. Users can press this line button
to park a call or retrieve a parked call.” section
on page 52.
The Call Park code field contains the star code
used for parking a call. Defaults to *68. The unPark
code field contains the star code used for
retrieving a parked call. Defaults to *88.
You can change these values to the values used
by the call server (for example, the BroadSoft
server).
BLF List URI Automatically configures Busy Lamp Field (BLF)
subscriptions for all users on a monitored list.
NOTE This feature generates the BLF configuration to
the attendant console keys, not the regular line keys.
Use Line Keys For BLF List Set the parameter to yes, to use the the line keys
first for Broadsoft BLF list feature. Default is no.
NOTE Previously, the phone used only side-car keys
for Broadsoft BLF list feature
Parameter Description
To Next Page
Loading...
Need help?
General
