Cisco TelePresence SX80 Administrator's Guide

D15328.04 SX80 Administrator Guide CE8.2, OCTOBER 2016. www.cisco.com — Copyright © 2016 Cisco Systems, Inc. All rights reserved.
40
Cisco TelePresence SX80 Administrator Guide
Set up Intelligent Proximity for content sharing (page 4 of 4)
About privacy
In the Cisco Privacy statement and the Cisco Proximity
Supplement you find information about data collection in the
clients and privacy concerns that needs to be considered
when deploying this feature in the organization. Refer to:
► http://www.cisco.com/web/siteassets/legal/privacy.html
You can temporarily disable Proximity in a meeting from the Touch
controller. This is useful in meetings where you want to prevent
devices in the room from receiving content.
You cannot temporarily disable Proximity if using the TRC6 remote
control.
Room considerations
Room acoustics
• Rooms with hard surfaces may cause challenges due to
severe audio reflections. Acoustical treatment of meeting
rooms is always highly recommended for the best meeting
experience as well as Intelligent Proximity performance.
• Cisco recommends only one video system with Intelligent
Proximity enabled in a room. Otherwise, interference is likely
to occur, which may lead to problems with device discovery
and session maintenance.
Basic troubleshooting
Cannot detect devices with Proximity clients
• Check if the video system is in standby mode. Ultrasound is
not transmitted if the speakers (for example a TV in standby
mode) are turned off.
• Check the speaker volume. The volume control on a speaker
itself (not the volume controlled using the remote control or
Touch 10) affects the ultrasound volume. If the volume is too
low, the listening devices cannot detect the ultrasound pairing
messages.
• Some Windows laptops are not able to record sound in the
ultrasound frequency range (20
kHz-22 kHz). This can be due
to frequency limitations with the sound card, sound driver or
the internal microphone of the particular device. Refer to the
Support forum for more information.
Audio artifacts
If you can hear audio artifacts, like humming or clipping noise,
decrease the maximum ultrasound volume (Peripherals > Pairing
> Ultrasound > Volume > MaxLevel).
Additional resources
Cisco Intelligent Proximity site:
► https://www.cisco.com/go/proximity
Support forum:
► https://www.cisco.com/go/proximity-
support
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices

Configuration

Cisco TelePresence SX80 Specifications

General

Maximum frame rate	60 fps
Supported video modes	720p, 1080p
Video formats supported	H.261, H.262, H.263, H.264, H.265
Supported graphics resolutions	1280 x 720 (HD 720), 1920 x 1080 (HD 1080)
Voice codecs	G.711, G.722, G.722.1, G.729ab
Noise reduction	Yes
HDMI ports quantity	5
DVI-D ports quantity	1
USB 2.0 ports quantity	2
Product color	Silver
Rack capacity	1U
Number of persons	0 person(s)
Analog signal format system	NTSC, PAL
Security algorithms	HTTPS, SSH
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Supported network protocols	SIP, H.323, ISDN, TCP/IP, DHCP, QoS
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Sensor type	-
Image sensor size	- \

Weight and Dimensions

Depth	309.8 mm
Width	442 mm
Height	44 mm
Weight	3650 g