Codan 9390 User Manual

Display messages
10-4 9390 Reference manual
Message Meaning Action
Channel used This channel already exists
and you are about to change
its channel settings.
Continue unless you do not want
to change this channel. See
Chapter 3, Customising
channels.
Clarifier Clarifier mode has been
selected.
Clarify by using the
Select
knob
on the control panel. Refer to the
9390 User guide, Chapter 4,
Using Clarifier mode.
Cloning failed Cloning the transceiver has
failed.
Check the programming cables.
Switch the transceiver off and
then on again. Try cloning again.
If the problem remains, contact
your Codan agent for help.
Cloning
finished
Cloning has completed
successfully.
None.
Completed The transceiver has finished
loading information from
the 9300 ALE controller.
None.
Data The transceiver is in Data
mode.
None.
Disconnect Err The transceiver received a
‘disconnect call’ when it
was not operating with an
IPC-500.
If the problem remains, contact
your Codan agent for help.
Empty scan
table
No channels have been set
up in the selected scan
table.
To set up a scan table, see
Chapter 3, Creating a scan table.
Error PIN
mismatch
You entered a different
number the second time you
entered your new PIN.
Set up the PIN again. See
Chapter 9, PIN setup.

Codan 9390 Specifications

General

Brand	Codan
Model	9390
Category	Transceiver
Language	English