Compaq ProLiant ML570

3-48 Compaq ProLiant ML570 Maintenance and Service Guide
Table 3-18
Array Diagnostic Utility (ADU) Error Messages
continued
Message Description Recommended Action
Swapped cables or
Configuration error
detected.
A drive
rearrangement was
attempted while an
expand operation
was running. This is
an unsupported
operation.
SOLUTION: Power
down system then
move drives back to
their original
location. Power on
system and wait for
the expand operation
to complete before
attempting a drive
rearrangement.
One or more drive locations were
changed while an expand operation
was in progress.
1. Power down the server.
2. Place the drives back in their original
locations.
3. Restart the server, and complete the
expand operation.
4. Move the drives to their new locations after
the expand operation is completed.
Swapped cables or
Configuration error
detected.
An unsupported
drive arrangement
was attempted.
SOLUTION: Power
down system then
move drives back to
their original
location.
One or more physical drives were
moved, causing a configuration that
is not supported.
Move all drives back to their original locations,
and refer to your user documentation for
supported configurations.
Swapped cables or
Configuration error
detected.
The cables appear to
be interchanged.
SOLUTION: Power
down system then
move the drives or
cables back to their
original location.
ADU has detected a change in the
cable configuration.
One or more cables may be
attached to the incorrect bus.
-Or-
One or more drives have been
moved to new locations.
Refer to your user documentation for supported
configurations and cabling guidelines.
Restore to the original configuration.
continued