Compaq ProLiant ML570

Diagnostics and Troubleshooting 3-49
Table 3-18
Array Diagnostic Utility (ADU) Error Messages
continued
Message Description Recommended Action
Swapped cables or
Configuration error
detected.
The configuration
information on the
attached drives is
not backward
compatible with this
controller’s
firmware.
SOLUTION: Upgrade
the firmware on this
controller. If this
doesn’t solve the
problem then power
down system then
move drives back to
the original
controller.
The current firmware version on the
controller cannot interpret the
configuration information on the
attached drives.
Upgrade the firmware.
-Or-
If that does not solve the problem, move the
drives back to the original controller.
Swapped cables or
Configuration error
detected.
The maximum
logical volume count
X was exceeded
during logical
volume addition. All
logical volumes
beyond X have been
lost and cannot be
recovered.
SOLUTION: Identify
the drives that
contain the lost
logical volumes.
Move those drives to
another controller
where the logical
volumes can be
recreated. NOTE! If a
drive contains a
valid logical volume
and a lost logical
volume, then do not
move that drive to
another controller.
More logical drives were created
than are supported on this
controller, causing lost logical drive
volumes.
Identify the drives containing lost volumes, and
move them to another controller so the lost
volumes can be recreated.
WARNING: Do not move a drive if it also
contains valid volume data. This process causes
all valid data to be destroyed!
continued