Compaq ProLiant ML570 - Page 192

10 Compaq ProLiant ML570 Server Maintenance and Service Guide
integrated server management,
features 3-58
Integrated Smart Array Controller
connector, identified 4-4
inter-controller link connection could
not be established 3-39
interlock LEDs See system interlock
LEDs
Internal Diagnostics Display (IDD)
function 4-14
identifying trouble
conditions 4-14
indicator, illustrated 4-14
locating 4-14
IP access 3-64
IP/IPX, using network features 3-60
IRQ conflict, resolving 3-3
J
jumper settings, obtaining 3-3
K
keyboard
connector, identified 4-4
part number 1-8
test error codes 3-25
kits
hardware, part number 1-5
power cable, part number 1-8
signal cable, part number 1-8
L
labels
symbols on equipment 2-3
LEDs
CD-ROM drive indicator 4-19
diskette drive indicator 4-19
hot-plug hard drive 4-20
hot-plug power supply 4-18
power switch 4-11
power switch connector,
identified 4-5
RJ-45 network connector status
illustrated 4-17
viewing 4-17
locking casters
part number 1-3
removing 2-8
removing, illustrated 2-8
replacing 2-8
logical drive problems, ADU error
messages 3-40
logical drive X
failed due to cache error 3-40
status = failed 3-40
status = interim recovery 3-40
status = loose cable
detected 3-40
status = overheated 3-40
status = overheating 3-40
status = recovering 3-40
status = wrong drive
replaced 3-41
loose cable detected—logical drives
may be marked FAILED until
corrected 3-41
M
maintenance and service guide, part
number 1-8
mass storage devices
location 2-20
maximum number
supported 2-20
memory
errors, recorded to Critical Error
Log 3-68
expansion board, removing 2-37
installation guidelines 2-36
maximum supported 2-36
module
part number 1-7
size 5-4
removing, illustrated 2-39
replacing 2-36
socket locations, illustrated 2-36
speed 5-4
standard 2-36
test error codes 3-24
upgrade requirements 5-4
memory board
16-DIMM, part number 1-7
connector, identified 4-3
memory expansion board,
replacing 2-37
mirror data miscompare 3-41
mirror problems, ADU error
messages 3-41
modem
test error codes 3-28
when used with ASR-2 3-60
mouse connector, identified 4-4
N
NC3123 Fast Ethernet NIC PCI
10/100 Wake on LAN (WOL)
part number 1-7