Compaq ProLiant ML570

14 Compaq ProLiant ML570 Server Maintenance and Service Guide
Repaired, defined 3-53
Status, defined 3-53
security, ASR-2 3-67
sense connector, identified 4-5
serial connectors, identified 4-4
serial port, test error codes 3-28
Server Documentation CD 2-41,
3-58
Server Health Logs 3-68
server power, removing 2-5
set configuration command
issued 3-44
shipping materials, part number 1-8
signal cable kit, part number 1-8
Smart Array 4200 controller
data transfer method 5-9
dimensions 5-9
drives supported 5-9
height 5-9
power requirements 5-9
SCSI port connectors 5-9
specifications 5-9
temperature range 5-9
thickness 5-9
transfer rate 5-9
SmartStart and Support Software CD
contents 3-5
running utilities 3-5
running utilities from 3-6
starting from 3-4
soft firmware upgrade required 3-44
software error
recovery from 3-59, 3-61
recovery start option 3-61
recovery timeout 3-61
spare parts list 1-7
specifications
controller 5-7
diskette drive 5-4
hard drives 5-8
IDE CD-ROM drive 5-5
NC3123 Fast Ethernet NIC PCI
10/100 Wake on LAN
(WOL) 5-6
operating 5-1
optional hardware 5-1
performance 5-1
physical 5-1
power supply 5-3
Smart Array 4200 controller 5-9
system unit 5-2
standby recovery
server option 3-61
server port 3-61
timeout 3-61
standby, effects 2-4
storage automatic reconstruction,
defined 3-71
storage enclosure on SCSI bus X
has a cabling error 3-45
indicated a door alert 3-45
indicated a power supply
failure 3-45
indicated an overheated
condition 3-46
indicated that a fan module is
unplugged 3-47
indicated that the fan
failed 3-46
indicated that the fan is
degraded 3-46
is unsupported with its current
firmware version 3-46
wide SCSI transfer failed 3-47
storage fault recovery tracking,
defined 3-71
Survey Utility, viewing 3-54
SW1 See peripheral board
SW6 See system board
ID/miscellaneous switch
swapped cables or configuration error
detected
cables may be
interchanged 3-48
configuration information on the
attached drive is not
backward compatible with
the controller’s
firmware 3-49
configured array of drives was
moved from another
controller 3-47
drive rearrangement was
attempted while an expand
operation was running 3-48
maximum logical volume count
X was exceeded 3-49
unsupported drive arrangement
was attempted 3-48
switchbank SW1 and SW2
750-MHz processor,
illustrated 4-8
switches
core frequency, settings 4-8
diskette start feature,
settings 4-6
lock configuration, settings 4-6
maintenance, settings 4-6
power on password, settings 4-6
Power On/Standby
removing, illustrated 2-55
power, part number 1-5