Compaq ProLiant ML570

Index 13
R
rack-mount bezel
part number 1-3
removing 2-11
removing, illustrated 2-11
replacing 2-11
Rapid Recovery Engine,
enabling 3-58
rapid recovery services 3-58
rear panel connectors
description 4-2
identified 4-2
illustrated 4-2
recovery
attended 3-59
automatic 3-58, 3-59
environmental 3-59
rapid recovery services 3-58
software error 3-59
unattended 3-59
redundant controller
configuration 3-41, 3-50
redundant controllers installed are not
the same model 3-50
redundant ROM image
recovery 3-74
remote management features,
defined 3-72
remote service features,
defined 3-72
removable media blanking panel
removing 2-26
removing, illustrated 2-26, 2-37
replacing 2-26
removable media device
removing 2-27
removing, illustrated 2-27
replacing 2-27
removable media drive,
location 2-20
removal and replacement procedures,
preparation 2-4
replacement battery, part
number 1-8
resource conflict, resolving 3-3
return kit, part number 1-8
Revision History Table
accessing 3-70
defined 3-70
storage location 3-70
RIS copies between drives do not
match 3-42
RJ-45
connector location 4-2
network connector status LEDs
illustrated 4-17
viewing 4-17
receptacle symbol 2-3
ROM
disaster recovery 3-73
flashing 3-73
ROMPaq
disaster recovery 3-73
Firmware Upgrade Utility,
accessing 3-5
recovery options 3-73
S
screwdriver symbol 2-3
SCSI cable
internal/external, part
number 1-9
option board, part number 1-9
SCSI CD-ROM drives See
CD-ROM drives
SCSI connectors, identified 4-4
SCSI hard drive blanking panel,
replacing 2-21
SCSI hard drives See hot-plug SCSI
hard drives. See hard drives
SCSI hot-plug drive cage with 6-bay
backplane board, part
number 1-3
SCSI port X, Drive ID Y
failed – REPLACE (failure
message) 3-42
firmware needs upgrading 3-42
has exceeded threshold(s) 3-42
is not stamped for
monitoring 3-43
may have a loose
connection 3-43
RIS copies within this drive do
not match 3-43
S.M.A.R.T. predictive failure
errors have been detected in
the (factory) Monitor and
Performance data 3-43
S.M.A.R.T. predictive failure
errors have been detected in
the Monitor and Performance
data 3-44
was replaced on a good volume:
(failure message) 3-44
SCSI tape drives See tape drives
SDRAM DIMM See memory
security levels
Caution, defined 3-53
Critical, defined 3-53