SLBMaxSlots Specifies maximum number of slots for IP and
network stickiness. (Default: 2048)
SLBNetSize Specifies network size for network stickiness.
(Default: 24)
SLBNewPort Rewrite destination port to this port. (Optional)
SLBMonitorRoutingTable Routing table used for server monitoring. (Default:
main)
SLBMonitorPing Enable monitoring using ICMP Ping packets.
(Default: No)
SLBPingPollingInterval Delay in milliseconds between each ping interval.
(Default: 5000)
SLBPingSamples Specifies the number of attempts to use for
statistical calculations. (Default: 10)
SLBPingMaxPollFails Specifies the maximum number of failed ping
attempts until host is considered to be
unreachable. (Default: 2)
SLBPingMaxAverageLatency Specifies the max average latency for the sample
attempts. (Default: 800)
SLBMonitorTCP Enable monitoring using TCP handshakes. (Default:
No)
SLBTCPPorts Specifies the ports that will be monitored.
SLBTCPPollingInterval Delay in milliseconds between each TCP
handshake. (Default: 10000)
SLBTCPSamples Specifies the number of attempts to use for
statistical calculations. (Default: 10)
SLBTCPMaxPollFails Specifies the maximum number of failed TCP
attempts until host is considered to be
unreachable. (Default: 2)
SLBTCPMaxAverageLatency Specifies the max average latency for the sample
attempts. (Default: 800)
SLBMonitorHTTP Enable monitoring using HTTP requests. (Default:
No)
SLBHTTPPorts Specifies the ports that will be monitored. (Default:
80)
SLBHTTPPollingInterval Delay in milliseconds between each monitor
interval. (Default: 10000)
SLBHTTPSamples Specifies the number of attempts to use for
statistical calculations. (Default: 10)
SLBHTTPMaxPollFails Specifies the maximum number of failed HTTP
attempts until host is considered to be
unreachable. (Default: 2)
SLBHTTPMaxAverageLatency Specifies the max average latency for the sample
Chapter 3: Configuration Reference
206
To Next Page
Loading...
