DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
130
After clicking the Show Detail button, the following page will be available.
Figure 6-10 IPv6 Interface (Detail, IPv6 Interface Settings) Window
The fields that can be configured are described below:
Parameter Description
IPv6 State
Select to enable or disable the IPv6 interface global state here.
Click the Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
The fields that can be configured for IPv6 Address Autoconfig are described below:
Parameter Description
State
Select to enable or disable the automatic configuration of the IPv6 address using
stateless auto-configuration here.
Select the Default option to insert the default route to the IPv6 routing table based
on the received router advertisement. The type of the default route is SLAAC.
Click the Apply button to accept the changes made.
The fields that can be configured for Static IPv6 Address Settings are described below:
Parameter Description
IPv6 Address
Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to
configure an IPv6 address on the interface using the EUI-64 interface ID. Select
the Link Local option to configure a link-local address for the IPv6 interface.
Click the Apply button to accept the changes made.
The fields that can be configured for NS Interval Settings are described below:
Parameter Description
NS Interval
Enter the Neighbor Solicitation (NS) interval value here. The range is from 0 to
3600000 milliseconds, in multiples of 1000. If the specified time is 0, the router will
To Next Page
Loading...
