DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
267
SNTP Settings
This window is used to display and configure the Simple Network Time Protocol (SNTP) settings.
To view the following window, click Time > SNTP Settings, as shown below:
Figure 14-18 SNTP Settings Window
The fields that can be configured in the SNTP Global Settings section are described below:
Parameter Description
SNTP State
Select to enable or disable the SNTP feature here.
Poll Interval
Enter the poll interval value here. The range is from 30 to 99999 seconds. By
default, this value is 720 seconds.
Click the Apply button to accept the changes made.
The fields that can be configured in the SNTP Server Setting section are described below:
Parameter Description
IPv4 Address
Enter the IPv4 address of the SNTP server here.
Click the Add button to add the SNTP server to the configuration.
Click the Delete button to remove the SNTP server from the configuration.
To Next Page
Loading...
