DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
210
Network Access Authentication Port Settings
This window is used to display and configure the network access authentication port settings.
To view the following window, click Security > Network Access Authentication > Network Access Authentication
Port Settings, as shown below:
Figure 9-55 Network Access Authentication Port Settings Window
The fields that can be configured are described below:
Parameter Description
From Port - To Port
Select the port(s) for the configuration here.
Periodic
Select to enable or disable periodic re-authentication for the selected port here.
This parameter only affects the 802.1X protocol.
ReAuth Timer
Enter the re-authentication timer value here. The range is from 1 to 65535
seconds. By default, this value is 3600 seconds.
Restart
Enter the restart time value used here. The range is from 1 to 65535 seconds. By
default, this value is 60 seconds.
Click the Apply button to accept the changes made.
To Next Page
Loading...
