DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
134
IPv4 Route Table
This window is used to display and configure the IPv4 route table settings.
To view the following window, click L3 Features > IPv4 Route Table, as shown below:
Figure 6-16 IPv4 Route Table Window
The fields that can be configured are described below:
Parameter Description
IP Address
Select and enter the single IPv4 address here.
Network Address
Select and enter the IPv4 network address here. In the first space enter the
network prefix and in the second space enter the network mask.
Connected
Select this option to display only connected routes.
Hardware
Select this option to display only hardware routes. Hardware routes are routes
that have been written into the hardware chip.
Summary
Select this option to display a summary and count of the route sources configured
on this Switch.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Static/Default Route
This window is used to display and configure the IPv6 static or default routes.
To view the following window, click L3 Features > IPv6 Static/Default Route, as shown below:
Figure 6-17 IPv6 Static/Default Route Window
To Next Page
Loading...
