DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
252
The fields that can be configured are described below:
Parameter Description
Language File Click the Browse button and navigate to the language pack file on the local PC
here. This file will be uploaded to the Switch.
Click the Apply button to initiate the language pack upload and installation.
Reset
This window is used to reset the Switch’s configuration to the factory default settings.
To view the following window, click Tools > Reset, as shown below:
Figure 13-19 Reset Window
Select one of the following options:
• The Switch will reset to its factory default settings and then save, reboot.
• The Switch will reset to its factory default settings and then save, reboot. This option excludes the IP address.
• The Switch will reset to its factory default settings and not reboot.
Click the Apply button to initiate the reset.
Reboot System
This window is used to reboot the Switch and alternatively save the configuration before doing so.
To view the following window, click Tools > Reboot System, as shown below:
Figure 13-20 Reboot System Window
When rebooting the Switch, any configuration changes that was made during this session, will be lost unless the Yes
option is selected when asked to save the settings.
Click the Reboot button to alternatively save the settings and reboot the Switch.
To Next Page
Loading...
