DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
132
Click the Edit button to configure the following parameters:
Figure 6-13 IPv6 Interface (Detail, Neighbor Discover, Edit) Window
The fields that can be configured are described below:
Parameter Description
Preferred Life Time
Enter the preferred lifetime value here. The range is from 0 to 4294967295
seconds. The default value is 604800 seconds (7 days).
Valid Life Time
Enter the valid lifetime value here. The range is from 0 to 4294967295 seconds.
The default value is 2592000 seconds (30 days).
Link Flag Select to enable or disable the on-link flag here. The default option is Enabled.
Autoconfig Flag
Select to enable or disable the auto-configure flag here. The default option is
Enabled.
Click the Apply button to accept the changes made.
After selecting the DHCPv6 Client tab option, at the top of the page, the following page will be available.
Figure 6-14 IPv6 Interface (Detail, DHCPv6 Client) Window
Click the Restart button to restart the DHCPv6 client service.
The fields that can be configured for DHCPv6 Client Settings are described below:
Parameter Description
Client State Select to enable or disable the DHCPv6 client service here. Select the Rapid
Commit option to proceed with two-message exchange for address delegation.
The rapid-commit option will be included in the Solicit message to request a two-
message handshake.
Click the Apply button to accept the changes made.
IPv4 Static/Default Route
This window is used to display and configure the IPv4 static and default route settings. The Switch supports static
routing for IPv4 formatted addressing. Users can create up to 124 static route entries for IPv4. For IPv4 static routes,
once a static route has been set, the Switch will send an ARP request packet to the next hop router that has been set
To Next Page
Loading...
