DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
149
Parameter Description
selected, then both the IPv4 and IPv6 DSCP will be marked. Setting the DSCP
will not affect the CoS queue selection.
New CoS
Select the new CoS value to packets here. The range is from 0 to 7. Setting the
CoS will not affect the CoS queue selection. The CoS will only be marked.
New Cos Queue
Select the new CoS queue value to packets here. This will overwrite the original
CoS queue selection. Setting the CoS queue will take effect if the policy map is
applied on the interface.
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
Policy Binding
This window is used to display and configure the policy binding settings.
To view the following window, click QoS > Advanced Settings > Policy Binding, as shown below:
Figure 7-15 Policy Binding Window
The fields that can be configured are described below:
Parameter Description
From Port - To Port
Select the range of ports that will be used for this configuration here.
Direction Select the direction option here. Input specifies ingress traffic.
Policy Map Name Enter the policy map name here. This name can be up to 32 characters long.
Select the None option to not tie a policy map to this entry.
Click the Apply button to accept the changes made.
To Next Page
Loading...
