DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
6
Click the Exit button to discard the changes made, exit the Smart Wizard, and continue to the Web UI.
Click the Next button to accept the changes made and continue to the next step.
Step 2 - System IP Information
In this step, we can configure System IP Information.
NOTE: The Switch will probe for surveillance devices every 30 seconds. If a surveillance device is
not in the same subnet as the switch, it will not be discovered automatically. Place the Switch
management IP in the same subnet as the surveillance devices for ONVIF cameras to be
added to the Surveillance Mode Web UI automatically.
Figure 2-4 System IP Information
The fields that can be configured are described below:
Parameter Description
Static
Select this option to manually assign and configure the IP address settings for the
Switch.
DHCP
Select this option to obtain IP address settings automatically from a DHCP server
for the Switch.
IP Address After selecting the Static option, manually enter the IP address of the Switch here.
Netmask After selecting the Static option, manually select the Netmask option here.
Gateway After selecting the Static option, manually enter the IP address of the default
gateway here.
Tick the Ignore the wizard next time option to skip the Smart Wizard on the next login.
To Next Page
Loading...
