DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
269
Parameter Description
Gateway
Enter the IPv4 address of the default gateway here.
Click the Apply button to accept the changes made.
The fields that can be configured in the SNMP Host Settings section are described below:
Parameter Description
Host IPv4 Address
Enter the IPv4 address of the SNMP host here.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
The fields that can be configured in the Log Server section are described below:
Parameter Description
Host IPv4 Address
Enter the IPv4 address of the SNMP server here.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
The uplink ports join all surveillance VLANs since they forward surveillance traffic to other switches. It is
recommended to connect uplink ports to the other switches because the discovery process is disabled on these ports.
The fields that can be configured in the Uplink Port Settings section are described below:
Parameter Description
From Port / To Port
Select the uplink port range that will be used here.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Surveillance Log
This window is used to display the surveillance log.
To view the following window, click Surveillance Log, as shown below:
Figure 14-20 Surveillance Log Window
To Next Page
Loading...
