DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
251
Parameter Description
will be used as the packets’ source IP address sent to the remote host, or as
primary IP address.
Click the Start button to initiate the Ping Test for each individual section.
The fields that can be configured in IPv6 Ping are described below:
Parameter Description
Target IPv6 Address
Enter an IPv6 address to be pinged.
Domain Name
Select and enter the domain name of the system to discover.
Ping Times
Enter the number of times desired to attempt to Ping the IPv6 address configured
in this window. Users may enter a number of times between 1 and 255.
Tick the Infinite check box to keep sending ICMPv6 Echo packets to the specified
IPv6 address until the program is stopped.
Timeout Select a timeout period between 1 and 99 seconds for this Ping message to reach
its destination. If the packet fails to find the IPv6 address in this specified time, the
Ping packet will be dropped.
Source IPv6 Address
Enter the source IPv6 address. If the current Switch has more than one IPv6
address, you can enter one of them to this field. When entered, this IPv6 address
will be used as the packets’ source IPv6 address sent to the remote host, or as
primary IPv6 address.
Click the Start button to initiate the Ping Test for each individual section.
After clicking the Start button in IPv4 Ping section, the following IPv4 Ping Result section will appear:
Figure 13-17 Ping (Start) Window
Click the Stop button to halt the Ping Test.
Click the Back button to return to the IPv4 Ping section.
Language Management
This window is used to install the language file to the Switch.
To view the following window, click Tools > Language Management, as shown below:
Figure 13-18 Language Management Window
To Next Page
Loading...
