DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
135
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix Length Enter the IPv6 address and prefix length for this route here. Tick the Default
Route option to use this route as the default route.
Interface Name
Enter the name of the interface that will be associated with this route here.
Next Hop IPv6 Address
Enter the next hop IPv6 address here.
Backup State Select the backup state option here. Options to choose from are Primary, and
Backup. When the Primary option is selected, the route is specified as the
primary route to the destination. When the Backup option is selected, the route is
specified as the backup route to the destination.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Route Table
This window is used to display and configure the IPv6 route table.
To view the following window, click L3 Features > IPv6 Route Table, as shown below:
Figure 6-18 IPv6 Route Table Window
The fields that can be configured are described below:
Parameter Description
Connected
Select this option to display only connected routes.
Database
Select this option to display all the related entries in the routing database instead
of just the best route.
Summary Select this option to display a summary and count of the route sources configured
on this Switch.
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
To Next Page
Loading...
