DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
217
Storm Control Settings
This window is used to display and configure the storm control settings.
To view the following window, click Security > Storm Control Settings, as shown below:
Figure 9-63 Storm Control Settings Window
The fields that can be configured in Storm Control Trap Settings are described below:
Parameter Description
Trap State
Select the storm control trap option here. Options to choose from are:
• None - Specifies that no traps will be sent.
• Storm Occur - Specifies that a trap notification is sent when a storm event is
detected.
• Storm Clear - Specifies that a trap notification is sent when a storm event is
cleared.
• Both - Specifies that a trap notification is sent when a storm event is
detected and/or cleared.
Click the Apply button to accept the changes made.
The fields that can be configured in Storm Control Polling Settings are described below:
Parameter Description
Polling Interval
Enter the interval value used here. This value must be between 5 and 600
seconds. By default, this value is 5 seconds.
Shutdown Retries
Enter the shutdown retries value used here. This value must be between 0 and
360. By default, this value is 3. Tick the Infinite option to disable this feature.
Click the Apply button to accept the changes made.
The fields that can be configured in Storm Control Port Settings are described below:
Parameter Description
From Port - To Port
Select the appropriate port range used for the configuration here.
To Next Page
Loading...
