DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
66
D-Link Discovery Protocol
This window is used to display and configure the D-Link Discovery Protocol (DDP) settings.
To view the following window, click Management > D-Link Discovery Protocol, as shown below:
Figure 4-46 D-Link Discovery Protocol Window
The fields that can be configured in D-Link Discovery Protocol are described below:
Parameter Description
D-Link Discovery Protocol
State
Select to globally enable or disable the DDP feature here.
Report Timer
Select the report timer value here. This is used to configure interval between two
consecutive DDP report messages. Options to choose from are 30, 60, 90, 120
seconds, or Never. Selecting Never instructs the Switch to stop sending report
messages.
Click the Apply button to accept the changes made.
The fields that can be configured in DDP Port Settings are described below:
Parameter Description
From Port - To Port
Select the range of ports that will be used for this configuration here.
State
Select to enable or disable the DDP feature on the specified port(s) here.
Click the Apply button to accept the changes made.
To Next Page
Loading...
